Dee-zee DZ1032 Instrukcja Użytkownika

Before returning this product to the store of purchaseContact Dee Zee if you experience the following problems:    •MissingParts   •Installat

Drill 1/4" holes up through the board using either the 1st and 3rd slots in the brace,or the 2nd and 4th slots in the braces as location guides.A

Pressing the flap up against the wheel well, drill a 1/4" holes through the hole in the mud flapinto the sheet metal of the wheel well. The fron

Dee Zee Running Board Installation InstructionsCongratulations on your purchase of a quality Dee Zee product. Dee Zee isrecognized as having the highe

BD 1032 LP/RP1 LH / 1 RHGSK-4116.5 FT.FP0321P/2P1 LH / 1 RHB 1984PX6BRACKETB 1985PX6B 134X6PN 70X24PN 72X 66FRAME BRACKET 1/4 X 3/4" HEXHEAD BOLT

WRENCH/RATCHET3/8", 7/16"TAPEMEASURETIN SNIPS3/16" DRILL BIT1/4" DRILL BITPlace the rubber trim onto the back lip of the runni

Measure back from the front wheel well and mark the lower rocker panel at 22", 47" and 76".This will be the approximate location for th

Attach the rocker brackets [E] to the rocker panel with a ribneck carriage bolt [K],washer [H], and nut [I].The top portion of the bracket should be i

Attach the frame bracket [F] to the angle brace using two hex head bolt [G], four washer [H], and two nuts [I]. Do not completely tighten at this time

Place the running board on the angle braces. Adjust the angle braces as needed to insure thatholes can be drilled through the brite tread to attach i

Attach the frame bracket to the frame using two sheet metal screws [J] using a 3/8" socket.Remove the clamps holding the frame bracket [F] to the