Dee-zee DZ1532 Instrukcja Użytkownika

Before returning this product to the store of purchaseContact Dee Zee if you experience the following problems:    •MissingParts   •Installat

Drill 1/4" holes up through the slots into the board at the locations shown below.Attach the running board to the angle brace using the hex head

Dee Zee Running Board Installation InstructionsCongratulations on your purchase of a quality Dee Zee product. Dee Zee isrecognized as having the highe

K2014PX2EC RSPX4B 1791PX4B 1984PX6BRACKETB 1985PX6B 134X6PN 70BX38PN 72BX 821/4" HEX NUT SHEETMETAL SCREW1/4 X 1" RIBNECKCARRIAGE BOLTDee Ze

WRENCH/RATCHET3/8", 7/16"TAPEMEASURE3/16" DRILL BIT1/4" DRILL BITPre-assemble the end cap [B] and strap bracket [C] using two

Measure back from the front wheel well and mark the lower rocker panel at 22", 47" and 76".This will be the approximate location for th

Attach the rocker brackets [E] to the rocker panel with a ribneck carriage bolt [K],washer [H], and nut [I].The top portion of the bracket should be i

Attach the frame bracket [F] to the angle brace using two hex head bolt [G], four washer [H], and two nuts [I]. Do not completely tighten at this time

Place the running board on the angle braces. Adjust the angle braces as needed to insure thatholes can be drilled through the bottom of the board to

Attach the frame bracket to the frame using two sheet metal screws [J] using a 3/8" socket.Remove the clamps holding the frame bracket [F] to the