Dee-zee DZ3030 Instrukcja Użytkownika

Before returning this product to the store of purchaseContact Dee Zee if you experience the following problems:    •MissingParts   •Installat

Attach the running board to the angle brace using the 1/4" x 1" ribneck carriage bolt [N], 1/4" flat washer [I], and 1/4" hex nut

Attach the mudflap using two sheet metal screws [K].Check to insure that all hardware has been tightened.Repeat process for other side of vehicle.13DZ

Dee Zee Running Board Installation InstructionsCongratulations on your purchase of a quality Dee Zee product. Dee Zee isrecognized as having the highe

REG CABX2REG CABX2FP0311PX1VARIESX2B 2008RPX3B 2008LPX3FP0312PX1REG CABX1REG CABX8REG CABX12GSK-41VARIESPN 685X2PN 686X12PN 525X18REG CABX16REG CAB12P

WRENCH/RATCHET3/8", 7/16"TAPE13mm, 15mmMEASURETIN SNIPS 1/4" DRILL BITPlace the bulb-seal gasket [E] onto the backlip of the runing bo

Locate the hexagon shaped holes on the inside of the rocker panel. There will be two holesat each mounting location. The passenger side is shown bel

Use the nutsert set tool [F] to crimp the nutserts in the holes.Hold the nut on the set tool with a 15mm wrench. Tighten the bolt in the set tool wit

When the brace is put up to the vehicle mounting location, the threaded plate must go into the large slot above the nutserts previously installed.Thre

Push up on the brace to put tension on the threaded plate in the large slot. Tighten the bolt with the threaded plate using a 13mm socket. Air tools

Place the running board on the braces with the bulb seal up against the rocker panel.The back lip of the board must sit on the outside of the rocker p