Dee-zee DZ1061 Instrukcja Użytkownika

Before returning this product to the store of purchaseContact Dee Zee if you experience the following problems:    •MissingParts   •Installat

Place the running board on the braces with the bulb seal up against the bottom of the vehicle.Align the board with the vehicle and make sure that the

Using the slots in the brace as a guide, drill a 1/4" hole at each mounting location.Clamp the board to the brace to hold it in position.Attach t

Pressing the flap up against the wheel well, drill two 3/16" holes through the hole in the mud flapinto the sheet metal of the wheel well. Attac

Dee Zee Running Board Installation InstructionsCongratulations on your purchase of a quality Dee Zee product. Dee Zee isrecognized as having the highe

B 2230LPX2 REGULAR CABVARIESX1 LH/ X1 RHB 2230LPX3 EXTENDED/CREW CABB 2229PX1B 2230RPX2 REGULAR CABB 2230RPX3 EXTENDED/CREW CABPN 525X12PN 909X12FP020

WRENCH/RATCHETTORQUE WRENCHCLAMP21mm, 13mm, 3/8", 7/16"TIN SNIPSThere is a difference in the bracket mounting between the gas and the diesel

Remove the bolt from the body shock mount at each of the mounting locations using a 21mm socket.Put the body shock mount bolt through the hole in the

Locate the bracket mounting locations on the inside of the rocker panel. Shown below is the driver side of the crew cab. The front of the vehicle is

Install the 8mm U-nut [F] in all of the mounting locations, unless there is a weld nut.Thread an 8mm bolt [E] part way into all of the top mounting lo

Slide the open end of the slot in the driver side brace [B] over the 8mm bolt.Attach the bottom mounting location using the 8mm bolt [E].Tighten the 8

Place the bulb-seal gasket [H] onto the backlip of the runing board [A]. Cut the bulb-seal gasketwith tin snips so that it is flush with the ends of