Dee-zee FX12358 Instrukcja Użytkownika

Before returning this product to the store of purchaseContact Dee Zee if you experience the following problems:    •MissingParts   •Installat

2007 - 2010 Driver Side Front BraceLocate the front sub-box support as shown below. Remove the factory bolt holding the frame tothe bottom of the sub

2007 - 2010 Driver Side Front Brace (continued)Place a 3/8" threaded plate [P] into the end of the sub-box support and align with the hole.Put th

2007 - 2010 Driver Side Rear BraceLocate the rear sub-box support as shown below. Remove the factory bolt holding the frame tothe bottom of the sub-b

2007 - 2010 Driver Side Rear Brace (continued)Place the support bracket [G] into the sub-box support. Attach using a 1/4 x 1 1/4" hex head bolt

2010 - Current Driver Side Front BraceLocate the rear sub-box support as shown below. Remove the factory bolt holding the frame tothe bottom of the s

2010 - Current Driver Side Rear BraceLocate the rear sub-box support as shown below. Remove the factory bolt holding the frame tothe bottom of the su

2010 - Current Driver Side Rear Brace (continued)Put the 8mm bolt [X] through the 8mm washer [Y] and a bent spacer [W], then put the bolt throughthe s

Attach the angle brace [V] to the main upright braces using the 1/4" x 1" hex head bolt [S],the 1/4" flat washer [T], and the 1/4"

Align the bolt in the channels on the bottom of the running with the slots in the angle braces andinsert the bolts into the slots. Attach the running

Pressing the flap up against the wheel well opening, drill three 1/8" holes through the mudflap andthe sheet metal of the wheel well. Secure the

Dee Zee Running Board Installation InstructionsCongratulations on your purchase of a quality Dee Zee product. Dee Zee isrecognized as having the highe

BD 12349 L/RBD 12348 L/RBD FX12949 L/RGSK-15BD FX12948 L/RX2GSK-414 FT/6.25FTMUDFLAP1 LH / 1 RHB 1648LP1 LH / 1 RHB 1648LPX2B 1648RPX2B 1382NX2PN 86AX

PN 325X2WRENCH/RATCHET3/8", 7/16", 9/16"TAPE13mm, 18mmMEASURETIN SNIPSPHILLIPS SCREWDRIVER1/8" 3/16" 1/4" OR PHILLIPS

Place the end cap [D] onto the running board as shown below. The image shown is the drivers sideside box board. Secure the end cap in place using a

The installation of the board brackets will vary depending on the model year of the vehicle.On the following pages, find the appropriate section for y

1999 -2007 Driver Side Front Brace (continued)Place the support bracket [G] into the sub-box support.Attach the support bracket to the sub-floor suppo

1999 -2007 Driver Side Rear BraceLocate the rear sub-box support as shown below. Remove the factory bolt holding the frame tothe bottom of the sub-bo

1999 -2007 Driver Side Rear BracePlace the left mounting bracket [E] up to the sub-box support and attach using the factory bolt previously removed.Pl